RO-400 Pumped 5-Stage Reverse Osmosis 400 US GPD
£433.91 Including VAT
RO-400 5 stage reverse osmosis water filter system with twin pumps and dual membrane for aquariums, drinking water, pharmaceuticals, plant propagation and window cleaning.
Free shipping on orders over £100!
- 120 Hour Guarantee
- Professional Shipping
- Secure Payments
- Coral Conditioning
- Personal Selection
RO-400 Pumped 5-Stage Reverse Osmosis 400 US GPD
Our RO-400 five stage water filter system is a professional under-counter system that helps to reduce harmful contaminants that find their way into groundwater, directly affecting private wells and municipal water systems. It is ideal for under sink point-of-use installation and provides a continuous supply of clean, filtered water that is suitable for households of all sizes.
This system is equipped with five. pre-filtration stages which are explained below
Further key features of this system include a high pressure switch to be used in conjunction with an automatic shut-off valve if adding a water storage tank, enabling the system to eliminate waste by closing the feed line when the tank is full or shut down and conserve power when the water pressure reaches 30 PSI. Automatic and manual flush valves to purge the reverse osmosis membranes prior to use, and a low pressure switch to safeguard the pump should the water supply fail, are also included as standard.
Our five stage water filtration system is factory tested and ready to use with connection hardware, tubing and instruction manual, all of which is designed to make installation and maintenance quick and easy without the need for a plumber.
It is offered as a complete set with filter cartridges, RO membranes, additional accessories and valves to prevent the membrane from becoming dried out.
System dimensions (H x W x D): 500 x 300 x 360 (mm)
Working Temp.: 5°C – 40°C (41ºF – 104ºF)
Operating Pressure: 1 bar (14.5 psi) – 6.0 bar (90 psi) If your incoming water pressure is above 4 bar a pressure regulator should be installed.
Inlet feed water connector: 3/8”
Flow rate: 400 gallons-per-day
Waste to product ratio is 3 to 1 (in optimum conditions, this unit will produce 63L of pure water per hour)
Typical Rejection Rate: 98% TDS (Total Dissolved Solids)
TDS (Total Dissolved Solids) < 1800 ppm
pH Parameters: 2 – 11
Iron: 0.2 ppm maximum
Turbidity < 5 NTU
Flow: 1.6 l/min
Max. inlet pressure: 10-40 psi
Max. outlet pressure: 70 psi
Dimensions (H x W x L): 20.7cm x 10.2cm x 10.3cm
Working Current: 1.6A
Transformer Ampage: 5A
Recommendations for Use:
Point-of-Use (POU) systems can filter out bad tastes, colours, odours, particulates, which pose no health risk but still affect the water quality
Recommended for water fed pole window cleaning, car valeting, aquatic organisms, hydroponics, large households
Ideal for domestic and commercial use where high volumes of purified water are required quickly
This system will improve the aesthetics of water used for drinking and cooking
Easy to transport, and simple to set up on site
Complete Package Contains:
The RO-400 is supplied with the following cartridges installed: PP, GAC, CTO
Automatic and manual flush valves, high pressure switch, low pressure switch
2 x EC-203-200A self-regulating pumps with safety step-down transformer
FDA approved water filter housings (including o’rings)
Feed water connector (can be fitted to copper mains water pipe)
RO membrane element type: 2 x 200 GPD thin film composite
Drain saddle valve, spanners for filter and RO housings
1/4″ tubing for system connection (5 metres)
3/8″ tubing for system connection (5 metres)
1800cc flow restrictor, automatic shut-off valve
STAGE, PART#, COMPONENT, FUNCTION:
PP – 10″ sediment cartridge (pre-filter) melt-blown polypropylene. 5 micron sediment filter reduces dirt, sediment, rust and other particulate matter.
GAC – 10” granular activated carbon cartridge (pre-filter). Coconut shell granular is used to reduce chlorine, colour, taste, odour, pesticides and organic impurities.
CTO – 10″ coconut shell carbon cartridge (pre-filter). Activated carbon block assures high-quality pur e water by further reducing chlorine, colour, taste, odour.
2 x 200GPD Membranes – Dual thin film composite reverse osmosis membrane (200 GPD – US Gallons – each), 0.0001 micron. Semi-permeable membrane reduces salts, minerals, metals, bacteria, viruses, cysts, TDS, hardness, fluoride, pesticides, lead, mercury, cadmium, arsenic and more. Due to the time needed to reduce all these ingredients we strongly recommend purchasing a water storage tank with your RO system.
T33 – In-line carbon cartridge (post-filter). Activated granular coconut shell carbon provides the final polishing and assures great-tasting drinking water.
Important: Do not use with water that is micro-biologically unsafe or of unknown quality without adequate disinfection before or after the system. Water filtration systems can help reduce the presence of contaminants. In addition, some water filtration systems can help reduce the presence of micro-organisms or other contaminants that pose potential health risks.
Limited Warranty: Vyair warrants that this product is free from defects in materials and workmanship. This warranty, together with any and all warranties implied by law, shall be limited to a period of twelve (12) months from the date of original purchase. This limited warranty does not apply to failures that result from abuse, misuse, alteration or failure to properly comply with installation, or cartridge change instructions. Vyair strongly recommends adding to all point of use filtration systems a Pressure Limiting Valve (contact us for further details) to guard against unwanted extreme water pressure events, pressure increases, surges, and water hammer which could occur in the water pipes. Not having one installed could mean that if you ever did have to claim damage caused by a burst water filter system, your claim could be denied.
Do not run a pump for more than 4 hours continuously. This is to stop the pump from overheating and becoming damaged. To achieve this, we would suggest installing some form of timer, so that after 4 hours of operation the pump has a 15-30 minute break. This will enable the pump to cool down.
The warranty for the pump would be null and void if no timer is used. If there is an issue with the pump we would ask for evidence of a timer being used to allow the item to be covered by the warranty
Do not allow the pump to run dry (without an active water source) as this will damage the pump. The only time that we would suggest running the pump without an active water supply is if you have a low pressure switch wired into the pump, as this will automatically switch the pump off when the incoming water flow is turned off.
The warranty for the pump would be null and void if used in an application of running dry without a low pressure switch- We will ask for evidence of use of a low pressure switch to receive a warranty replacements of the pump
We suggest that the pumps are permanently mounted. This is to stop any potential for the pump to vibrate and become damaged.
We will ask for evidence of how the pump is mounted for the item to be covered by its warranty.