The Osmotics RO system includes:-
- 1 x 100 US gallon per day membrane
- 1 x 5 micron Sediment Pre-filter
- 1 x Carbon Block Pre-filter
- 1 x 330ml Refillable Deionisation Post Filter (resin included for 2 fills)
- 1 x Feed Water Clamp
- 1 x Waste Water Clamp
- 1 x Filter Housing Wrench
- 2 Metres of Red Tubing
- 2 Metres of Green Tubing
- 2 Metres of Blue Tubing
- 1 x Membrane Flush Kit *
- 1 x Pressure Gauge
* Using the flush valve regularly increases membrane life.
All Osmotics Reverse Osmosis Systems are shipped fully assembled complete with comprehensive instruction manuals and have the added benefit of email support round the clock.
The effectiveness and productivity of RO systems increase with greater water pressure and temperature. The actual flow rate (in GPD) of any reverse osmosis system depends on your home water pressure and temperature.
While manufacturers state that 60 psi is required at the membrane for full production, we know that not everyone’s cold water is at 60 psi and 77 degrees F therefore, we remind you that you might get less than 100 GPD, perhaps 50% or even less if your pressure and temperature are very low!
So when the flow rate is critical for you, you need to consider all these factors.
All RO units should have their prefilters changed every 6 months or 2500gallons throughput, whichever comes sooner. The prefilters protect the membrane from sediment and chlorine which will damage the most expensive element.
The Deionisation stage may need refilling more regularly than the prefilters, it depends entirely on how your unit is performing and how much water you produce. Loose Deionisation Resin for this unit can be ordered from the in 1,5,10 and 25-litre quantities.